Inventory Optimization > Scenario Results > Scenario Analysis > SKU Overrides Page > SKU Overrides Page (Access Settings)
SKU Overrides Page (Access Settings)
Access to the SKU Overrides page and the actions you can perform on the page are determined by the following settings:
Global Settings 
Global Setting
Effect
This is used to restrict access to scenarios, locations, configurable filters and minimum and maximum SKU Overrides.
This is used to calculate the default setting of the End Date when a SKU override is created.
* 
Update this value to be greater than 0 to use either End Date limits, Maximum Quantity limits, or both
This is used to require additional confirmation for values that are larger than this global setting value.
* 
A default value of 0 for both MEO_OVERRIDE_DEFAULT_PERIODS_TO_EXPIRE and MEO_OVERRIDE_MAX_QTY global settings results in no changes to the behavior of overrides.
Security Settings 
Confirm that SKU Override security is properly configured.
• If you are running the Gateway in batch mode, the user that submits the job must have access to all SKUs that are being loaded into the IPCSDD_SKU_OVERRIDE table.
• If the user does not have access to a SKU on a record, when the Get Host Data AutoPilot process is run, that record is saved as a SKU Override with the following settings:
◦ A Status of Rejected
◦ An Override Note of Rejected during system import - Security check failed
• The Planner entered in the HostRecommenderPlannerID field in the IPCSDD_SKU_OVERRIDE table must have access to the SKU on the record. If the Planner does not have access to the SKU on the record, when the Get Host Data AutoPilot process is run, that record is saved as a SKU Override with the following settings:
◦ A Status of Rejected
◦ An Override Note of Rejected during system import - Security check failed
* 
There is no validation of the HostReviewerPlannerID on the IPCSDD_SKU_OVERRIDE table
The user that is running the Gateway process is validated with the entries on the User Templates page
• If the Planner entered in the HostRecommenderPlannerID field in the IPCSDD_SKU_OVERRIDE table and there is no matching Planner defined in Servigistics, then the record is saved as a SKU Override with the following settings:
◦ A Status of Rejected
◦ The Planner ID on the SKU Override is set to the user ID of the user that is running the Get Host Data AutoPilot process
◦ An Override Note of Rejected during system import - HostPlannerID was not valid
User Rights 
These user rights on the Inventory Optimization tab of the User Rights Setup page determine the page access:
These user rights on the Inventory Optimization tab of the User Rights Setup page determine the available actions that can be performed.
• Global Access
For each user, select Allow for the View, Recommend, and Review All Optimization Results
• Segment Access
For each user, set the segment assignments on the Override Assignment page. This grants the user access to SKU Overrides and running the Get Host Data AutoPilot process.
* 
If a SKU is new and not in the IPCS_PREPROCESSED table, then the Override Assignment security will not find the SKU in any segment and therefore the record will be rejected with an Override Note of Rejected during system import - Security check failed
Was this helpful?